Creation date: Mon 25 Feb 2013 10:43:56 PM PST Revised: Thu 27 Mar 2013 ECB dual SD I/O board, rev. 1.01 * = change from rev. 1.00 #Cmp ( order = Reference ) | C1 47uF * ; was 22uF -- increase to 47uF to 100uF electrolytic | C2-C22 .1uF ; qty 21, monolithic or ceramic (21 places) | C39 4.7uF * ; was 1uF -- increase to 4.7uf to 10uf electrolytic | C40 33nF * ; 0.033uF (up to 0.1uF) ceramic or monolithic (may use same as C22) | D1,D2 LED ; 5mm or 3mm LED (2 places) | D3 1N4148 ; best is BAT43, 1N914, 1N5820 (Jameco 177973) | K1 C96ABC ; 96-pin DIN connector, male, rt angle (Jameco 859430) | K2 CONN_3 ; 3-pin jumper block from a single row snappable header | P1,P2 SDCARD-MINI_03; SD card socket, top mount, Digikey (FCI or TEconn) and Mouser have them | P3 CONN_6X2 ; no component installed here (see configuration instructions) | P4 CONN_6X2 ; " " " " | P5 CONN_7X2 ; 7x2 jumper block from a double row snappable header | P6 CONN_3X2 ; 3x2 jumper block from a double row snappable header | R1,R2 330 ; 330 ohm 1/8w 10% | RR1 1000 ; 1K ohm bussed (7-10 pin package) | RR2 10K ; 10K ohm bussed (4-10 pin package) | RR3 47K * ; 47K ohm bussed (9-10 pin package) (22K...47K okay, higher the better) | U1 LP2950-3.3 ; TO-92 3.3v regulator 100ma (Jameco 1323397) | U2 74LS00 ; 2-input NAND | U3 74LS86 ; 2-input XOR | U4,U5,U6 74LS38 ; 2-input NAND, open-collector (DO NOT USE CMOS) | U7,U11 74LS175 ; quad D-flop | U8,U10,U13 74LS244 ; 8 wide bus receiver/driver, true, tri-state | U9,U12 74LS157 ; quad 2-line to 1-line mux (U9 MUST be ALS or LS!!!) | U14 74LS240 ; 8 wide bus receiver/driver, compl, tri-state | U15 74LS682 ; 8 wide comparator | U16 74LS138 ; 3-line to 8-line multiplexor | U17 DIL20 ; spare position (no component) | U18 DIL16 ; " " #End Cmp #End List